[Live-devel] RTP sink to serial

[Yedidia Amit]

Thanks Ross.
1. Does SLIP itself requires Full Duplex channel (I don't RTCP RR nor
TCP) ?
2. Yes .I do expect moderate data loss and bit errors. Any ideas?

Regards,


Amit Yedidia
Elbit System Ltd.

Email: amit.yedidia at elbitsystems.com
Tel: 972-4-8318905
----------------------------------------------------------

 

> -----Original Message-----
> From: live-devel-bounces at ns.live555.com 
> [mailto:live-devel-bounces at ns.live555.com] On Behalf Of Ross Finlayson
> Sent: Sunday, November 23, 2008 6:32 PM
> To: LIVE555 Streaming Media - development & use
> Subject: Re: [Live-devel] RTP sink to serial
> 
> >1. Does the SLIP needs full duplex channel (I need data 
> transfer only in
> >one direction)
> 
> Yes, you need a full duplex channel, for RTCP "Receiver Report" 
> packets coming back from the receiver.  You would also need a 
> full-duplex channel if you want RTP-over-TCP (see below).
> 
> >2. If I want to add some error detection and error resilience bits,
> >outside the Live555 (the live will receive/send normal IP packets
> >from/toward the SLIP), is there clean way to implement it?
> 
> No, not really.  But do you really expect much data loss over your 
> SLIP channel?  If so, you could do RTP-over-TCP.
> -- 
> 
> Ross Finlayson
> Live Networks, Inc.
> http://www.live555.com/
> _______________________________________________
> live-devel mailing list
> live-devel at lists.live555.com
> http://lists.live555.com/mailman/listinfo/live-devel
> 

The information in this e-mail transmission contains proprietary and business 
sensitive information.  Unauthorized interception of this e-mail may constitute 
a violation of law. If you are not the intended recipient, you are hereby 
notified that any review, dissemination, distribution or duplication of this 
communication is strictly prohibited. You are also asked to contact the sender 
by reply email and immediately destroy all copies of the original message.