[Live-devel] Question about transmitting MPEG2 Transport Stream...

[Jason Huang]

Dear Ross,

	I have the same question mentioned here.
	I followed the instructions in FAQ and tried the multicast the MPEG2
TS File by modifying "testMPEG1or2VideoStreamer"
	But the following error message still comes out :

	MPEG1or2VideoStreamParser::parseSlice(): Saw unexpected code 0x1c0

	Do you have any suggestions or is there any sample code which can
probably play MTS format files?


 

-----Original Message-----
From: live-devel-bounces at ns.live.com [mailto:live-devel-bounces at ns.live.com]
On Behalf Of Ross Finlayson
Sent: Monday, April 19, 2004 5:59 PM
To: LIVE.COM Streaming Media - development & use
Subject: Re: [Live-devel] Question about transmitting MPEG2 Transport
Stream...


>Recently,I try to transmit MPEG2 Transport Stream according to the 
>FAQ(How can this code be used to send or receive 
>MPEG-2TransportStreams?).Unfortunely
>the result seems wrong.the packet accepted at client(mplayer) was 
>bad,because the decoded frames quality was very bad and have a lot of
blocks.

Were the sender and receiver running on the same computer, or on different
computers?  If they were running on different computers, then are you sure
that you have enough network bandwidth between them to handle the stream?
(MPEG-2 Transport Streams can be several 10s of Megabits per second.)


	Ross Finlayson
	LIVE.COM
	<http://www.live.com/>

_______________________________________________
live-devel mailing list
live-devel at lists.live.com
http://lists.live.com/mailman/listinfo/live-devel